SDR Compatible With RSP1 HF AM FM SSB CW Aviation Band 10Khz - 1Ghz Software Defined Radio Receiver

• This receiver adopts msi2500 msi001 scheme, simplified RSP1 circuit, the interface is USB Type-C interface.

  Equipped with 5 antenna interfaces correspond to different frequency band.

  Effective frequency ranges from 10KHz to 1GHz, 12bit ADC resolution, full 10M real-time visual bandwidth (real-time monitoring of 10M wide signal ranges, such as 430-440MHz).
  

  
  

  KEY FEATURES:
  

  Chip Set: msi2500 msi001

  Continuous coverage from 10kHz to 1GHz

  12-bit ADC silicon technology

  Low noise floor

  Simple USB interface (Type-C )

  5 SMA antenna socket

  Powers over the USB cable

  HDSDR,SDR#,SDR Console

  Ideal for portable operation

  No need for an up-converter

  Covers all amateur bands from experimental LF throughHF, VHF and UHF

  Simultaneous entire amateur band monitoring possible

  Works with all the popular SDR software (including HDSDR, SDR Console, Cubic )

  Compatible with existing open source radio software (Airspy ,HDSDR, SDR consol, and GNURadio , SDRuno SDRPlay)
  

  ExtIO based plugin available

  Multiplatform support including Windows, Linux, Mac, Android and Raspberry Pi 2/3

  Connectivity:

  Single 50Ω RF connector (SMA)

  USB 2.0 (high speed) type C socket

  Frequency Range: 
  Continuous coverage 10kHz – 1GHz

  
  

  Please Note:

  No case, usb cable, or antenna.

  Needs external antennas to match the selected band to receive good signals
  5 x SMA port, Need to manually switch the antenna

  Board maybe slightly different from the pictures
  

  
  

  Software Download:
  Download SDRuno for windows.

  First Install all the components before connecting the board, then connect the board through USB-C cable.
  It will automatically detects the board and can go from there.

  
  Watch this video for SDRuno for beginners. 

  
  

  Sample screen shot (SDRuno):